Mark Rakestraw
04-30-2008, 4:51 PM
Yes, I posted this a while ago....I took your advice and took it in to the service center and told them about bogging down under load and needing a new speed control board. They wound up replacing bearings and brushes instead, saying that was the problem. While it does run better, it still bogs down, so you guys were right and they were wrong. Now I can spend another $95 on this thing. I'm not crazy about giving PC more of my money since of the 7 PC tools I've bought 4 have been junk. But I have the Bench-dog Prolift, which I love, for it so I'm stuck with a 7518. A while back someone considered ripping out the electrical innards and using an after-market speed control. Did you do it?? Did it work??
thanks,
Mark
thanks,
Mark