Orlando Gonzalez
04-28-2008, 9:45 PM
I have the Byrd Shelix installed on my 6" PM jointer and I have a couple of questions:
1 - What is the proper alignment of the cutterhead in relation to the outfeed table, that is, it aligned even with the outfeed table or slightly above it (.001-.002).
2 - Is this measurement take from the highest insert next to the fence and the one on the next spiral furthest away from the fence.
Thanks
Orlando
1 - What is the proper alignment of the cutterhead in relation to the outfeed table, that is, it aligned even with the outfeed table or slightly above it (.001-.002).
2 - Is this measurement take from the highest insert next to the fence and the one on the next spiral furthest away from the fence.
Thanks
Orlando