Chris Yarish
04-28-2008, 2:34 PM
It was under some obvious load from some 12/4 stock, but was cutting fairly smoothly, then it bogged a bit, then shut off completely.
I've never had problems with it in the past. This is a first.
I checked the breaker and reset my power. Unplugged it and plugged it back in, checked to make sure the belts are still intact, but I'm afraid that the motor may have gone south. There is not a single sound or noise from it when I press the on button, nor is there any "click" when I push either the on or off button. I am motor and electricity challenged so don't want to get too investigative without some guidance.
Any ideas what it might be, or what I can do?
The machine is likely 20-30 years old. Perhaps older.
I've never had problems with it in the past. This is a first.
I checked the breaker and reset my power. Unplugged it and plugged it back in, checked to make sure the belts are still intact, but I'm afraid that the motor may have gone south. There is not a single sound or noise from it when I press the on button, nor is there any "click" when I push either the on or off button. I am motor and electricity challenged so don't want to get too investigative without some guidance.
Any ideas what it might be, or what I can do?
The machine is likely 20-30 years old. Perhaps older.