PDA

View Full Version : Cutting Rubber Magnet on Epilog Mini 35watts



jay vyas
04-22-2008, 4:20 AM
hey guys i wanted ask wether is it fine if i cut a rubber magnet on epilog mini 35watts if yes then what should be the speed power and frequency for a .75mm rubber magnet??? :)

David Fairfield
04-23-2008, 8:26 AM
The user manual has power settings for rubber. Personally I cut as little rubber as possible, as it produces a lot of soot. I cut a few hundred small rubber gaskets it was a dirty job.

I tried minimizing the soot by layering between wet newspapers, but then you have a lot of pieces of very dirty wet newspaper to clean up. Plus the finished parts needed a bath and the machine needed cleaning.

Dave

jay vyas
04-24-2008, 1:08 AM
thanks for your reply and i will also try to make a punch instead of cutting on laser but for small orders its not possible to make a punch and get a punching machine so i thought of cutting on laser...