Fred Conte
04-20-2008, 5:29 PM
I'm thinking of using the following buffs for bowl finishing, both will be 3.5" and will order three of each.
Has anyone tried these? Comments or thoughts welcome...thanks!
For the sides/curved surfaces:
http://www.caswellplating.com/buffs/mush_buff.htm
For the inside bottom:
http://www.caswellplating.com/buffs/facer.htm
Also I got this motor today at a local flea market -$20. I turned the extension 8" x 1.25" to fit the shaft. In another post I was going to make a 3 on 1 but from my readings here decided to go the one at a time route. The motor specs are 3450 rpm @3/4 hp, it can be wired 120 or 220 vac and cw or ccw.
86864
Thanks for your comments/thoughts!:)
Fred
Has anyone tried these? Comments or thoughts welcome...thanks!
For the sides/curved surfaces:
http://www.caswellplating.com/buffs/mush_buff.htm
For the inside bottom:
http://www.caswellplating.com/buffs/facer.htm
Also I got this motor today at a local flea market -$20. I turned the extension 8" x 1.25" to fit the shaft. In another post I was going to make a 3 on 1 but from my readings here decided to go the one at a time route. The motor specs are 3450 rpm @3/4 hp, it can be wired 120 or 220 vac and cw or ccw.
86864
Thanks for your comments/thoughts!:)
Fred