Harry Radaza
04-17-2008, 10:26 PM
I am having trouble engraving on a rotary engraver. I need to cut Ostrich Eggs in half. I started by testing it out on an old wooden bracelet. Just engraving a straight line around it. I followed all the directions in the ULS manual. However, for some reason it wont go all the way around.
I have no problem aligning the X axis. The problem comes with the actual object ( a line ) that I put in Corel. I used the bracelets circumference as the length of the object from top to bottom. However, this still does not give a line that goes all the way through. I also inputted the actual diameter correctly and chose ROTARY in the Versalaser Advanced Control Panel.
Any ULS experts here?
I have no problem aligning the X axis. The problem comes with the actual object ( a line ) that I put in Corel. I used the bracelets circumference as the length of the object from top to bottom. However, this still does not give a line that goes all the way through. I also inputted the actual diameter correctly and chose ROTARY in the Versalaser Advanced Control Panel.
Any ULS experts here?