Ryan Eldridge
04-11-2008, 4:07 PM
Hi there all,
I made the mistake of flipping through craigslist today and came upon a Hitachi B-600A bandsaw. It looks like it is in good condition but who knows from the photos. Apparently it is the predecessor to the CB75F.
It's specs are as follows:
"sawing capacity" - 310mm (12.2 inches)
"table area" - 450 x 456 mm (17.1 x 17.9)
blade - 6 - 75 mm (1/4 - 3 inches) x2812mm (110.7 inches)
wheel diameter - 410mm (16.1 inch)
The guy is asking $500 for it, I was not really in the market for a resaw bandsaw but something that can resaw around 12" and run a alebit expensive 3" blade is kind of enticing to keep in the back corner of the garage to resaw some lumber with.
What do you guys think of this?
I put the picture below
I made the mistake of flipping through craigslist today and came upon a Hitachi B-600A bandsaw. It looks like it is in good condition but who knows from the photos. Apparently it is the predecessor to the CB75F.
It's specs are as follows:
"sawing capacity" - 310mm (12.2 inches)
"table area" - 450 x 456 mm (17.1 x 17.9)
blade - 6 - 75 mm (1/4 - 3 inches) x2812mm (110.7 inches)
wheel diameter - 410mm (16.1 inch)
The guy is asking $500 for it, I was not really in the market for a resaw bandsaw but something that can resaw around 12" and run a alebit expensive 3" blade is kind of enticing to keep in the back corner of the garage to resaw some lumber with.
What do you guys think of this?
I put the picture below