View Full Version : Spindle Adapters
Fred Conte
04-06-2008, 6:02 PM
I've been looking to purchase an adapter 1 1/4" x 8 to 1" x 8 and have noticed a wide range in pricing from $20 to $60 and was wondering what is the difference?
Are they all the same or are the more expensive ones machined better and use a better grade of steel? Any recommendations?
Thanks!
Fred
Bernie Weishapl
04-06-2008, 6:09 PM
Fred my experience has been you get what you pay for. I bought one from PSI and it had run out. I returned it and bought the one from CSUSA and it was dead on. It runs dead true. Just my experience and I am sure more will hopefully give you some info.
Fred Conte
04-06-2008, 7:44 PM
Thanks Bernie...
Yes I did look at both adapters that you referred to and didn't understand the differences.
I have the PSI Barracuda 2 chuck and am very pleased with it's quality but wasn't sure about their adapters.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.