Ken Cohen
03-31-2008, 8:56 AM
I was about to buy a hybrid TS (22124 or Jet) but ran into this opportunity for approximately $800:
Delta 3hp Unisaw, Table saw. 220 volt, single phase, left tilt unisaw. 50 inch Biesmeyer self aligning fence, two cast iron extensions, mobile base, dust collection port. This saw is about 5 years old and is in excellent mechanical and cosmetic condition. Fence is self aligning and accurate. The saw is in excellent running conditon. The very tip of the off button snapped off the magnetic switch. This is primarily a cosmetic flaw and does not affect the switch or saw performance in anyway.
Attached picture is several years old - and shows a good looking piece of equipment.
This seems like something I should jump at -- I have the space and can wire for 220. Pick-up is local.
Questions:
1. Is this as attractive a deal as it seems? How much higher should I offer to pay if a negotiation ensues?
2. What additional information, if any, should I seek out before making an offer?
Thanks in advance for the advice.
Ken
Delta 3hp Unisaw, Table saw. 220 volt, single phase, left tilt unisaw. 50 inch Biesmeyer self aligning fence, two cast iron extensions, mobile base, dust collection port. This saw is about 5 years old and is in excellent mechanical and cosmetic condition. Fence is self aligning and accurate. The saw is in excellent running conditon. The very tip of the off button snapped off the magnetic switch. This is primarily a cosmetic flaw and does not affect the switch or saw performance in anyway.
Attached picture is several years old - and shows a good looking piece of equipment.
This seems like something I should jump at -- I have the space and can wire for 220. Pick-up is local.
Questions:
1. Is this as attractive a deal as it seems? How much higher should I offer to pay if a negotiation ensues?
2. What additional information, if any, should I seek out before making an offer?
Thanks in advance for the advice.
Ken