xenetech 1625 rotary new viper upgrade

[roy coughlan]

Hi To All ..first Time Poster.. Greetings From The Green Isle..ireland..
Have A Xenetech 1625 Engraver About To Upgrade To The New Viper System , Any Advice, Or Views ,or Experience In The Use Of Same Much Appreciated.

Roy A Coughlan
Corkbrass

[Kelly Bingham]

Hi Roy!
Wish I was there in Ireland with you!!! :) Been once and wanting to go again. Hey, you need a new employee to run the viper?!?!? :D
It may take a couple days to get used to the small differences in the viper system. You cant set your pendant to auto-start job - I used this all the time! But your engraving table is faster. I havent had any problems with the viper. I like it - then again I am a Xenetech fan.....

Enjoy the upgrade - hope it goes smoothly!

:) kelly

[roy coughlan]

Hi Kelly,
Thanks For The Info Re The Viper..up And Running , Can Hardly Keep Up With The New Speed..
Roy