Paul Arnold
03-28-2008, 8:22 AM
What is the best way to set-up and cut box joints when there is a 10 degree angle on the ends of the pices you are trying to joint?
Lee DeRaud
03-28-2008, 10:33 AM
You mean something like this (http://www.sawmillcreek.org/showthread.php?t=31522)?
Not the only way, but what I did was cut the joint first, then bevel the fingers...there's a diagram in that thread that shows the process.
(If you mean something where the corner is square but the sides lean in, I have absolutely no idea.)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.