Bill Parker
03-10-2008, 9:50 PM
Hello Everyone,
I recently purchased a Pinnacle M-25 Series laser second hand, so I'm guessing Sign Warehouse won't give me support. I've been playing around with the power settings and have noticed that at 100% power with 100% speed and 0% power with 100% speed gives me the same outcome. No matter what % the power is I get the same outcome. If I slow the speed down, I will get a different outcome. I have tested this in CorelDraw x3 and also Engravelab using the print drivers, both with the same results.
My question is does anyone have a clue what I might be doing wrong? :confused::confused:
I also would like to thank everyone that has contributed to this forum, this is a great place and I have learned alot over the last few weeks.
I recently purchased a Pinnacle M-25 Series laser second hand, so I'm guessing Sign Warehouse won't give me support. I've been playing around with the power settings and have noticed that at 100% power with 100% speed and 0% power with 100% speed gives me the same outcome. No matter what % the power is I get the same outcome. If I slow the speed down, I will get a different outcome. I have tested this in CorelDraw x3 and also Engravelab using the print drivers, both with the same results.
My question is does anyone have a clue what I might be doing wrong? :confused::confused:
I also would like to thank everyone that has contributed to this forum, this is a great place and I have learned alot over the last few weeks.