Michael Wildt
03-03-2008, 8:30 AM
Hi,
I'm thinking of ordering a Kreg right angle clamp together with the master kit. The question is if I should get a total of 2 'right angle clamps' ?
I know the standard answer is, you can never have too many clamps, but since this pocket hole tooling is new to me I'm looking for some guidance :)
The project where this will be used is primarily for 90 degree joints.
Thanks
Michael
I'm thinking of ordering a Kreg right angle clamp together with the master kit. The question is if I should get a total of 2 'right angle clamps' ?
I know the standard answer is, you can never have too many clamps, but since this pocket hole tooling is new to me I'm looking for some guidance :)
The project where this will be used is primarily for 90 degree joints.
Thanks
Michael