Joe Pelonio
02-27-2008, 7:30 PM
The computer (Dell 4600 XP) running the laser just quit on me, I restart it and
it will not boot, but gives the following message:
yboard failure
I have a backup luckily but it's going to be a pain to switch over, what does this mean?
And why does it always happen when I'm really busy?
---------------------------
edit:
Hey, it's Keyboard failure I bet, probably the wide screen monitor won't show the ke. Working on it now, maybe a plug came out!
----------------------------
OK, I could just delete this, since it's fixed, but I'll leave it so you can all have a nice laugh at my expense.
I am running a vinyl job that's a total of 75 yards of 24", so as I plot I roll up each section and am leaving them all around the place until I get to weeding them. The pile tipped over and the weight of it was setting on the left edge of the keyboard, holding down a key or two. That's all.
it will not boot, but gives the following message:
yboard failure
I have a backup luckily but it's going to be a pain to switch over, what does this mean?
And why does it always happen when I'm really busy?
---------------------------
edit:
Hey, it's Keyboard failure I bet, probably the wide screen monitor won't show the ke. Working on it now, maybe a plug came out!
----------------------------
OK, I could just delete this, since it's fixed, but I'll leave it so you can all have a nice laugh at my expense.
I am running a vinyl job that's a total of 75 yards of 24", so as I plot I roll up each section and am leaving them all around the place until I get to weeding them. The pile tipped over and the weight of it was setting on the left edge of the keyboard, holding down a key or two. That's all.