Jointer Alignment Information

[Frederick Rowe]

Here is link to one of the best reference tables on causes and results of jointer misalignment I've seen.

http://home.usmo.com/~rfwoodworking/jointer.html (http://home.usmo.com/%7Erfwoodworking/jointer.html)

This topic regularly reoccurs, even for experienced users, this is handy as a quick reference guide.

[John Lock]

Great tips. I made sure to bookmark this one.

Thanks

[Eddie Darby]

Great post! Thanks!

One good turn deserves another ... or so I hope.

http://www.americanwoodworker.com/aspx/ContentDetail.aspx?ContentId=1041&PageNo=1

Article on how to set-up a jointer. Hope you like!:D

[Rick Lizek]

I agree it's it a good link, well thought out and executed but there is something one should pay close attenion to is the last two items are the most common causes of problems...knife height in relation to the outfeed table. The first three are the ones to look for if the last two don't solve the problem and require a straight edge to verify. I've been tuning and rebuilding machines professionally and follow these procedures. Unfortunately for a novice it's listed in a non-logical progression which is probably confusing to most folks.