Mike Watts
02-21-2008, 10:43 AM
Howdy all,
I am attempting to build a pedestal desk out of QSWO. This is the hardest project I have undertaken so far and would like some advice. When I set the side panels on top of each other the top and bottoms are aligned but the sides are 1/16 inch off from the top of the panel to the bottom which is flush. Hope this visual picture is clear. My question is if this is ok or should I square the panels with each other but that means that they are smaller than the base which is already made. In hind site I should have made the sides and back and then the base.
Thanks,
Mike
I am attempting to build a pedestal desk out of QSWO. This is the hardest project I have undertaken so far and would like some advice. When I set the side panels on top of each other the top and bottoms are aligned but the sides are 1/16 inch off from the top of the panel to the bottom which is flush. Hope this visual picture is clear. My question is if this is ok or should I square the panels with each other but that means that they are smaller than the base which is already made. In hind site I should have made the sides and back and then the base.
Thanks,
Mike