Ron Hamilton
02-19-2008, 2:56 AM
Hi all,
I have another question for users of the Accuris Powersharp 30 watt unit from Sign warehouse.
Just another problem to add to the list, (Kevin) if you are out there!
In the driver settings when I set the power/speed to, for an example value 30% power and 10% speed the computer software complies. However on the led readout on the laser is stays at 50% power and 100% speed.
This surely can no be correct? I fear that a main board is possessed or something and perhaps its the cause of my stepping problem previously mentioned in a thread.
Difficult to get answers between Canada and Texas (so much for free trade)
Ron..............
I have another question for users of the Accuris Powersharp 30 watt unit from Sign warehouse.
Just another problem to add to the list, (Kevin) if you are out there!
In the driver settings when I set the power/speed to, for an example value 30% power and 10% speed the computer software complies. However on the led readout on the laser is stays at 50% power and 100% speed.
This surely can no be correct? I fear that a main board is possessed or something and perhaps its the cause of my stepping problem previously mentioned in a thread.
Difficult to get answers between Canada and Texas (so much for free trade)
Ron..............