Steve Roxberg
02-17-2008, 10:10 PM
I am connecting my jointer with a short section of 6" flex. I have run spiral to about two feet away and into the spiral have put a pipe coupling that fits into the sprial on one end, and was going to put the flex over the other end.
It's nice and flat, smaller than the pipe itself and for the life of me I can't get the flex over the coupling.
I was going to use a Bessey clamp, or quick grip clamp as a spreader and they are both larger that the internal diamerter of the spiral.
Is there a trick that I'm missing?
Is there a fitting that I need?
Can anyone give me another way to stretch the flex out a little>
It's nice and flat, smaller than the pipe itself and for the life of me I can't get the flex over the coupling.
I was going to use a Bessey clamp, or quick grip clamp as a spreader and they are both larger that the internal diamerter of the spiral.
Is there a trick that I'm missing?
Is there a fitting that I need?
Can anyone give me another way to stretch the flex out a little>