View Full Version : Shelix cutter head question
C Scott McDonald
02-13-2008, 4:15 PM
Does any know if this cutter head will fit a Powermatic 60b?
http://www.grizzly.com/products/8-Shelix-Cutterhead/H7765
Or is that intended for Grizzly only?
Thanks!
Scott
Dick Adair
02-13-2008, 4:41 PM
Scott, page 46 of Grizzly catalog is a cross reference. The powermatic is listed. I just replaced mine on a Bridgewood, and I like it. For that # they list 6CB, PJ882.
C Scott McDonald
02-13-2008, 8:08 PM
Thanks Sir, I dont have a catalog but went to thier site and ordered one today. Did they list a cost with it?
Dick Adair
02-13-2008, 8:26 PM
$395.00... I also replaced the bearings after removing them with a puller. Just to be safe. If I did it again I would leave them on the old one. After everything was adjusted as for the table height, I only had about 1/16 inch clearance on the outfeed table and the head. I didn't measure it, but it appears the OD on the Shelix may be larger. It's quieter cutting, but my link belt screams now. Not sure if I need to replace the pulleys and go to the larger belt. Good luck.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.