Shelix cutter head question

[C Scott McDonald]

Does any know if this cutter head will fit a Powermatic 60b?

http://www.grizzly.com/products/8-Shelix-Cutterhead/H7765

Or is that intended for Grizzly only?

Thanks!
Scott

[Dick Adair]

Scott, page 46 of Grizzly catalog is a cross reference. The powermatic is listed. I just replaced mine on a Bridgewood, and I like it. For that # they list 6CB, PJ882.

[C Scott McDonald]

Thanks Sir, I dont have a catalog but went to thier site and ordered one today. Did they list a cost with it?

[Dick Adair]

$395.00... I also replaced the bearings after removing them with a puller. Just to be safe. If I did it again I would leave them on the old one. After everything was adjusted as for the table height, I only had about 1/16 inch clearance on the outfeed table and the head. I didn't measure it, but it appears the OD on the Shelix may be larger. It's quieter cutting, but my link belt screams now. Not sure if I need to replace the pulleys and go to the larger belt. Good luck.