View Full Version : Biesemeyer face plate is not flat??
Thomas Walker
02-05-2008, 12:34 PM
It's got a bow of about .009"
Is there a way to get the face off so I can shim it?
Mike Spanbauer
02-05-2008, 12:58 PM
Yes, heat gun. it's attached with adhesive and you can remove it via a putty knife and some gentle heat (be careful not to burn it.)
Then the face is attached with 4-6 screws. I can't remember the exact number as I've not taken mine off in a few years. Veneer tape is nice for shimming as it is SO thin.
mike
Jay Jolliffe
02-05-2008, 1:19 PM
Well.... I checked out mine & it's out .005" in the middle from end to end also put a square on the saw table & see if it's out than way. Mine is out about a 1/32"....
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.