Lori Kleinberg
02-04-2008, 3:01 PM
For those following my drill press saga, here is a short summary and update.
Ordered Steel City DP the end of October from Tool King.
Due to being out of stock and poor communication and then great customer service the DP was delivered the end of December.
Was out of town until after the new year, then had to get help to set it up.
80776
80777
80778
80779
80781
Now all I have to do is add the free laser that came with it and build a table for it.
Speaking of a table, Can I and would it be any good to face glue 2 pieces of melamine covered particle board together and what kind of glue should I use. I have some scrap pieces that are just about the right width and then I thought I would surround it with a hard wood frame.
Ordered Steel City DP the end of October from Tool King.
Due to being out of stock and poor communication and then great customer service the DP was delivered the end of December.
Was out of town until after the new year, then had to get help to set it up.
80776
80777
80778
80779
80781
Now all I have to do is add the free laser that came with it and build a table for it.
Speaking of a table, Can I and would it be any good to face glue 2 pieces of melamine covered particle board together and what kind of glue should I use. I have some scrap pieces that are just about the right width and then I thought I would surround it with a hard wood frame.