View Full Version : Your Favorite Material?
Jeff Gilchrist
01-31-2008, 9:31 PM
Hypothetical question --- If you were only allowed to produce your products using a single material, what would that material be and why?
Jeff
Earl Reid
01-31-2008, 9:46 PM
My choice by far is cherry.
It is abundent, It mellows with age, easy to work with, and is avaible at low cost:) Also I like it.
Earl
Ray Mighells
01-31-2008, 9:58 PM
If I could use just one material and obliged to not fudge, I'd probably stick to woodcarving. Just kidding. I like American Black Cherry for the above stated reasons and also because I have more than 10K pieces almost laser ready.
Bill Cunningham
01-31-2008, 10:10 PM
Glass... Everything you do on it looks good..
Mike Null
02-01-2008, 4:41 AM
Black brass. Looks great, foolproof-never a redo.
Frank Corker
02-01-2008, 8:18 AM
Cast acrylic. Clean, durable, simple and looks good. ( a bit like me )
Ryan Sprole
02-01-2008, 8:20 AM
My choice by far is cherry.
It is abundent, It mellows with age, easy to work with, and is avaible at low cost:) Also I like it.
Earl
+1 Wood is Good
Doug Bergstrom
02-01-2008, 8:51 AM
Black granite or marble. Looks sharp when finished and always has the wow factor at shows.
Rodne Gold
02-01-2008, 8:54 AM
Would have to be acrylic ,its almost foolproof on a laser and can be bent, moulded or glued with ease to make many many diverse products.
Angus Hines
02-01-2008, 9:04 AM
Acrylic...Its simple to run and much more versatile than some of the other products. Plus I like the way it smells when it cuts.
Robert Alexander
02-01-2008, 8:12 PM
For me is is matte board. It is cheap. I can do multi layered designs. And if I am doing a job for a customer and they want to see what the finished item will look like. I can do it on colored matte board,before lasering the expensive stuff. Here are some photos of some of my first tries on matte board
Keith Outten
02-01-2008, 9:10 PM
Dupont Corian
Kenneth Hertzog
02-01-2008, 10:37 PM
acrylic limited only by an imagination:rolleyes:
ken
Mark Winlund
02-02-2008, 4:08 PM
Acrylic
Mark
Larry Bratton
02-02-2008, 7:07 PM
I'm with Rodne and Frank..acrylic. It is very workable material in the laser. I also love to bend it and glue it up with Weldon #3.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.