Steve Roxberg
01-29-2008, 11:07 AM
I purchased a cyclone, and am now trying to find homes for the machines.
I am considering placing my router table along a wall that will only give me about four feet to the left and then to the right of the router bit.
Will I regret this?
I mainly use the router table for raised panel doors, and decrotive edges on smaller parts. An edge on a table top, or longer board I would probably do by hand.
Will I regret this decision, and am I missing something?
I am considering placing my router table along a wall that will only give me about four feet to the left and then to the right of the router bit.
Will I regret this?
I mainly use the router table for raised panel doors, and decrotive edges on smaller parts. An edge on a table top, or longer board I would probably do by hand.
Will I regret this decision, and am I missing something?