Glen Blanchard
01-26-2008, 2:59 PM
I have a DeWalt DW733 that has always worked extremely well. Here in the last week or so, I have noticed that my stock is not being fed through smoothly (as in, one continuous, uninterrupted motion) any longer. In fact, I am having to do a fair amount of pulling on the outfeed side to help it along.
I am fairly sure that the recommendations I have read in the past for this problem consisted of cleaning the rollers with isopropyl alcohol - which I have done - a couple of times now. This has not made an appreciable difference. Are there other recommendations? I would think that using Acetone would be less than desirable. Do these rollers sometimes need to be replaced?
Thanks in advance.
I am fairly sure that the recommendations I have read in the past for this problem consisted of cleaning the rollers with isopropyl alcohol - which I have done - a couple of times now. This has not made an appreciable difference. Are there other recommendations? I would think that using Acetone would be less than desirable. Do these rollers sometimes need to be replaced?
Thanks in advance.