Peter Meacham
01-22-2008, 2:10 PM
I receive an error message in Trotec Job Control "Cannot position any more jobs on this plate" when I try to send a job from the job queue to the plate.
I sent this same job earlier today with no problems.
This is a 12" x 12" job sending to a 28" x 17" plate. Smaller sized jobs, say 3" x 4", get to the plate OK.
I have a Speedy 100 machine.
I have rebooted, restarted Job Control, etc.
If I change the .ini file regarding table size, to slighly larger, the job I want to print works OK. However, my job has lots of registration marks and pre-positioned artwork that I don't want to reposition to accomodate the change to the .ini file.
It is obviously a size issue, but this job printed fine earlier and, in any case is much smaller than the plate size. It should print!!!
Any Trotec owners that have had this problem and can recommend a solution.
Thanks, Pete
I sent this same job earlier today with no problems.
This is a 12" x 12" job sending to a 28" x 17" plate. Smaller sized jobs, say 3" x 4", get to the plate OK.
I have a Speedy 100 machine.
I have rebooted, restarted Job Control, etc.
If I change the .ini file regarding table size, to slighly larger, the job I want to print works OK. However, my job has lots of registration marks and pre-positioned artwork that I don't want to reposition to accomodate the change to the .ini file.
It is obviously a size issue, but this job printed fine earlier and, in any case is much smaller than the plate size. It should print!!!
Any Trotec owners that have had this problem and can recommend a solution.
Thanks, Pete