Rabbit HX3040 table size

[James Jaragosky]

Well I have discovered that only 14 5/8 inches on my 18 cutting table is usable. Cutting anything longer than 14.58. is restricted due to software limitations. This came as a little shock, because it will cut the entire hight of the table and beyond, but not the length.

[Mike Hood]

That's too bad... but most all of us are a bit limited between full table size and usable area. Mine is only about 1/4 " less though.

[Jim Dornon]

My 3040 will engrave a size of 12"X16". It does however have a 93mm difference between the software 0,0 and the table software. X 0 is ok, it is on the edge of the honeycomb. The y is actually 93mm down from the software 0. So I just ad 93mm to the y location in the software. Made it difficult at first. NewlyDraw is also very unstable. Wants to lock up and not respond lots of times. Very tireing and time consuming. Other than that it seems to be doing well. Jim