Randy Davidson
01-18-2008, 11:43 AM
I have purchased the General Machinery 50-slt60 sliding table which is supposed to be the exact replacement for the Excalibur of the same model from Tools Plus. It came with no manual so I found a download and printed it off. Terrible instructions. Does anyone have a more complete manual I could copy?
After taking it apart 3 times I am still 1 1/8" off between the inside of the two rails. It also says to line the plate that replaces where the side table was with the arbor as close as possible. All the photos I see of this table have the rails extending in front of the saw and if I line up with the arbor it is 6" or so short of the front of the saw. Any suggestions?
I guess I should mention this is going on a PM66.
After taking it apart 3 times I am still 1 1/8" off between the inside of the two rails. It also says to line the plate that replaces where the side table was with the arbor as close as possible. All the photos I see of this table have the rails extending in front of the saw and if I line up with the arbor it is 6" or so short of the front of the saw. Any suggestions?
I guess I should mention this is going on a PM66.