Joe Pelonio
01-10-2008, 2:35 PM
I just got back from installing this on the wall of an office in
downtown Seattle. The logo is waterjet cut stainless steel, 9"x48",
the smaller letters below are laser cut 1/4" black acrylic, faces
painted light gray. I also laser cut some circles of acrylic to mount
the logo 1/2" off the wall. They were 1/4" thick so two glued together
to make the 1/2", and two on top have screws coming out the spacers
which are in the wall to carry the weight.
I had the stainless cut by another Creeker.
Thanks for your help, Jack!
downtown Seattle. The logo is waterjet cut stainless steel, 9"x48",
the smaller letters below are laser cut 1/4" black acrylic, faces
painted light gray. I also laser cut some circles of acrylic to mount
the logo 1/2" off the wall. They were 1/4" thick so two glued together
to make the 1/2", and two on top have screws coming out the spacers
which are in the wall to carry the weight.
I had the stainless cut by another Creeker.
Thanks for your help, Jack!