Derek Larson
01-06-2008, 10:31 AM
I saw a cabinet door that I thought was very interesting, and I was very curious how the profile on the rails and stile was done.
If you looked at the cross section of the rails and stiles you would see a subtle rounded profile that is approximately 2" wide.
I have looked for router bits that would create that rounded profile but to no avail am I missing something, is this some type of custom bit?
Again the key to this is that it is subtle and wide, any guesses?
Here is a link to a cabinet door that is close to what I saw just ignore the fancy cuts on the sides of the rail and stiles I am only curious about the round center of the stiles and rails
http://thomasvillecabinetry.com/Products/FinishDetail.aspx?DSFID=450
If you looked at the cross section of the rails and stiles you would see a subtle rounded profile that is approximately 2" wide.
I have looked for router bits that would create that rounded profile but to no avail am I missing something, is this some type of custom bit?
Again the key to this is that it is subtle and wide, any guesses?
Here is a link to a cabinet door that is close to what I saw just ignore the fancy cuts on the sides of the rail and stiles I am only curious about the round center of the stiles and rails
http://thomasvillecabinetry.com/Products/FinishDetail.aspx?DSFID=450