Shane Sura
01-05-2008, 4:41 PM
Hi All,
I am getting ready to attach my table top to the router cabinet I am finishing. The table top is from Hartville Tool and is made of MDF with High Pressure Laminate on each side. My question is how would you attach it? I made the cabinet out of 3/4" Oak Plywood and there is a solid back along with the two side and two inside risers that will make up the center cabinet for the router. I thought about using my pocket hole jig and connecting that way but was not sure. Also figure I need some type of glue but unclear what would attach with the laminate. Any advise?
Shane
I am getting ready to attach my table top to the router cabinet I am finishing. The table top is from Hartville Tool and is made of MDF with High Pressure Laminate on each side. My question is how would you attach it? I made the cabinet out of 3/4" Oak Plywood and there is a solid back along with the two side and two inside risers that will make up the center cabinet for the router. I thought about using my pocket hole jig and connecting that way but was not sure. Also figure I need some type of glue but unclear what would attach with the laminate. Any advise?
Shane