Newly Draw Questions

[Jim Dornon]

Ordered a Rabbit HX 3040, it came with Newly Draw. Does anyone use this software ? For the most part I figured out the cuting part, but when I try to engrave over the same spot as what I cut, I can't get it to engrave over the same place. Basicly if I draw a box and then cut it out I want to engrave over the same box, but can't get it to back to the spot that I need it to, such as dice. I cut out a templete to place the dice in but now I can't get it to engrave the where I need it to. Can I use Corel Draw to output to the engraver. Jim:confused:

[Mike Null]

Haven't used that software but can you engrave then cut?

[Jim Dornon]

Yes, but I am done cutting, I just need to engrave. The problem is that I can't seem to get the laser to engrave where the cut out is. Sfter I cut the templete I place the dice in the templete and engrave the dice. On the file I use it is the same templete as the cut templete and no out put for the cuting. It just won;t go to that location.