sharkguard on 22124 table saw

[david hines]

Hi all, I have a shark guard on order and I am looking for info on how you hooked yours up? Any help would be appreciated.The duct work is on the right side of the saw.How did you support yours? thanks david hines

[david hines]

bump any help out there?

[frank shic]

i slung a couple of ropes around it and threw them over the ceiling joists. the problem with this method is that it doesn't prevent the gravity that's pulling on the other end of the hose from pulling the bladeguard slightly sideways causing the bladeguard to sometimes interfere with the workpiece. when i get a chance i'm planning on getting several more lengths of tubing so that i can have a straight vertical drop from the ceiling to the guard.