Jon Lanier
01-01-2008, 5:31 AM
Here is a little experiment with logo's on wooden pens. It is a decal using some new Testors transparent custom decal system. Very, Very thin stuff. I first used CA over top and let it dry/cure, put the decal on and then another coat of CA on top.
This is the old fashion model decals like you use to do when you were a kid. But with this you print your own. Then spray a 'bonder' on top to seal in the colors. I did a few other "pen size" decals to try but not done them all yet. Our church logo, a picture of my son shooting hoops, Superman Shield etc.
This is an Atlas Pen, I have plenty of barrels but no kits. Woodcraft was out in my visit today. But that wasn't going to stop my idea from being tried. Bad photo... one day I'll put together a photo curtain thingy. (Oh.... that's Maple and Purple Heart)
http://img504.imageshack.us/img504/4780/sawmillcreekexperimentxc0.jpg
http://img526.imageshack.us/img526/2661/sawmillcreekexperiment2od1.jpg
This is the old fashion model decals like you use to do when you were a kid. But with this you print your own. Then spray a 'bonder' on top to seal in the colors. I did a few other "pen size" decals to try but not done them all yet. Our church logo, a picture of my son shooting hoops, Superman Shield etc.
This is an Atlas Pen, I have plenty of barrels but no kits. Woodcraft was out in my visit today. But that wasn't going to stop my idea from being tried. Bad photo... one day I'll put together a photo curtain thingy. (Oh.... that's Maple and Purple Heart)
http://img504.imageshack.us/img504/4780/sawmillcreekexperimentxc0.jpg
http://img526.imageshack.us/img526/2661/sawmillcreekexperiment2od1.jpg