Gary Herrmann
12-27-2007, 8:00 PM
I wound up going through the side on my pencil pot tonight. The inside wasn't all that even - I went through while sanding! Created a nice little slit on the side of the pot. Must have been where I had a catch.
I find it difficult to control the tool when its 4-5 inches over the tool rest in a confined space. Even the hunter tool was chattering and screeching.
I imagine I'll get better at as I try more. Hope so anyway. :rolleyes:
What are the rest of you doing to make pencil pots?
I suppose I can try a forstner bit next time. Probably have to clear it often to avoid bluing the bit. I wonder if there are better bits for that application?
I guess a hollow form tool is another option, but I think thats a while down the road for me yet. I spent a lot on tools this year.
Advice for a frustrated turner appreciated. Time for a beer.
Moderators - can you please move this to the turning forum? Apparently, I can't read.
I find it difficult to control the tool when its 4-5 inches over the tool rest in a confined space. Even the hunter tool was chattering and screeching.
I imagine I'll get better at as I try more. Hope so anyway. :rolleyes:
What are the rest of you doing to make pencil pots?
I suppose I can try a forstner bit next time. Probably have to clear it often to avoid bluing the bit. I wonder if there are better bits for that application?
I guess a hollow form tool is another option, but I think thats a while down the road for me yet. I spent a lot on tools this year.
Advice for a frustrated turner appreciated. Time for a beer.
Moderators - can you please move this to the turning forum? Apparently, I can't read.