PDA

View Full Version : Any tips for beer mugs?



Jerry Hay
12-27-2007, 7:06 PM
Hello again everyone,
Anyone have any good tips for doing beer mugs. it always seems like I put the handle in the wrong place and it hits the cradle or it will not center up right. I can etch pint glasses on one side awesome too but if I need to do both sides I am stuck.
Thanks for any help everyone.

Kenneth Hertzog
12-27-2007, 7:28 PM
Jerry
I set the mug on the rotary table with the handle down, On mine ( epilog ) I move the top wheel out so it catches the edge of the mug, then I move the base out so the flat spots don't hit the back wheels. Now to position the mug so the handle is on the backside of the rotation and measure and engrave.
does this help?:confused:
ken

Joe Mioux
12-27-2007, 8:36 PM
Cold And Clean!!!!


Joe

ps sorry I couldn't resist

Jerry Hay
12-28-2007, 8:18 PM
That helps a bunch. I will give it a try and see how it works.