Denny Wayman
12-26-2007, 6:57 AM
hello sawmill creek members
i have a question about my 3 HP shaper. I have a CMT cutterhead with the interchangable knives (insert tooling). my question is this:
When i run the shaper without the cutterhead, it purrs like a kitten, but whenever i install the large cutterhead and turn on the machine, it makes some noise. Not like a bad vibration or a grinding, just kind of a hum.
I haven't had much experience with shapers so the noise could be normal, and i'm pretty sure it is, i just wanted to try and get a second opinion.
thanks
i have a question about my 3 HP shaper. I have a CMT cutterhead with the interchangable knives (insert tooling). my question is this:
When i run the shaper without the cutterhead, it purrs like a kitten, but whenever i install the large cutterhead and turn on the machine, it makes some noise. Not like a bad vibration or a grinding, just kind of a hum.
I haven't had much experience with shapers so the noise could be normal, and i'm pretty sure it is, i just wanted to try and get a second opinion.
thanks