Jeff Cord
12-21-2007, 11:28 PM
I purchased a 22-580 (refurbished) months ago and am changing blades tonight for the first time.
First blade changed, no problem.
Remove the second blade and when I go to replace it I find the alignment pins for the blade are pushed completely flush with the cutterhead.
77689
This is the cutterhead where the pins are both flush with the cutterhead.
77688
This is the other side of the cutterhead and both pins are just fine.
I cannot see any way to adjust these to get them to protrude from cutterhead to actually align the blade and I'm stuck.
Does anyone know a way to adjust these pins?
Hopefully there's a way to do this cause if not then I'm stuck. :(
Thanks,
jeff
First blade changed, no problem.
Remove the second blade and when I go to replace it I find the alignment pins for the blade are pushed completely flush with the cutterhead.
77689
This is the cutterhead where the pins are both flush with the cutterhead.
77688
This is the other side of the cutterhead and both pins are just fine.
I cannot see any way to adjust these to get them to protrude from cutterhead to actually align the blade and I'm stuck.
Does anyone know a way to adjust these pins?
Hopefully there's a way to do this cause if not then I'm stuck. :(
Thanks,
jeff