Frank Corker
12-20-2007, 11:47 AM
Firmware Download
Last Update: 12/18/07
Version: 1.0.2.3 (replaces 1.0.2.1)
Changes:
Rotary Center-Center Engraving: When using the Center-Center feature with the Rotary Attachment, raster engraving would be offset in the Y-axis from the intended location. This has been resolved for all Epilog laser systems.
Rotary Auto Focus Position: When using Auto Focus with the Rotary Attachment the table could stall at the very bottom of its stroke. This was seen almost exclusively on the Mini 18, but the issue has been resolved on all Mini, Helix and EXT systems.
http://www.epiloglaser.com/downloads_minihelix.htm
Last Update: 12/18/07
Version: 1.0.2.3 (replaces 1.0.2.1)
Changes:
Rotary Center-Center Engraving: When using the Center-Center feature with the Rotary Attachment, raster engraving would be offset in the Y-axis from the intended location. This has been resolved for all Epilog laser systems.
Rotary Auto Focus Position: When using Auto Focus with the Rotary Attachment the table could stall at the very bottom of its stroke. This was seen almost exclusively on the Mini 18, but the issue has been resolved on all Mini, Helix and EXT systems.
http://www.epiloglaser.com/downloads_minihelix.htm