Joe Pelonio
12-19-2007, 11:13 AM
Unloading I dropped a piece of acrylic that I really needed into the front
between the table and the tube. I have dropped things in there before
over the years but this time rather than make a 20 minute drive I thought better to finally take the table floor off. What a gold mine of crud I found in there!:eek:
Someone confirm, if you have done this before, putting it back together:
1. Adjust level with screws that have washers, by moving head/focus tool around
2. Tighten screws that go into threads
3. Locktite on adjustment screws??
between the table and the tube. I have dropped things in there before
over the years but this time rather than make a 20 minute drive I thought better to finally take the table floor off. What a gold mine of crud I found in there!:eek:
Someone confirm, if you have done this before, putting it back together:
1. Adjust level with screws that have washers, by moving head/focus tool around
2. Tighten screws that go into threads
3. Locktite on adjustment screws??