PDA

View Full Version : Dust Shoe



Mark Winlund
12-09-2007, 2:29 PM
Here is a dust shoe I made for my new router. I have posted this on a couple of other forums, but I thought I would add some input to this one!

The shop photo shows my setup along with the shop supervisor, Duke.

Leo Voisine
12-18-2007, 7:57 PM
Mark,

Where did you get the brushes?

Larry Bratton
12-22-2007, 7:05 PM
Mark,

Where did you get the brushes?
Leo:
Don't know where he got that brush, but I just bought some for a new dust shoe we made for our machine. I got some that is nylon on a flexible pvc carrier. It worked great. I got it from http://www.tanisinc.com/strip.php Nice folks too!

Mark Winlund
12-25-2007, 3:23 PM
Hi Leo... sorry I haven't gotten back to you... this forum has not gotten up to speed yet, and I haven't checked it.

I got the brushes at the hardware store... they came with a tiny dustpan and were intended as a car accessory. Cost about $2 each. Much cheaper than anything else I could find.

Mark

Alan Gordman
01-07-2008, 8:33 AM
I imagine that such products are hard to find, that makes me think about the small entrepreneur surviving condition.

Chris Foley
01-07-2008, 11:45 AM
I see sources for this all the time in industrial quanities. Try looking at Grainger or McMaster-Carr. They will typically have this is the material handling and/gasket sections.

Good Luck!

Peter Meacham
01-09-2008, 9:06 AM
Mark

Real nice job on making the dust shoe - well done.

Pete