Sean Troy
12-07-2007, 12:03 PM
Fellow Creekers have sure saved me a lot of time and shared a lot of knowledge with me the short time I've been visiting this site. Most recent case is with my TS out feed table. I was going to make it so the total length including the TS table would be 8 ft. After reading lots of different posts, my mindset is starting to become that like a flat woodworker (I've always been a woodturner) I stoped and thought about the length of the table and started measuring and found out I can only make the table 4x4 plus the TS table saw top. I wasn't thinking about getting a full 4x8 sheet on the feed side or the outfeed side before this weird transistion to flat started taking over. You all saved me a lot of time and the 4x4 out feed table should be done today. Thanks, Sean