Rocko McCombs
12-04-2007, 11:11 PM
Hello,
I just got a lightly used Jet 14" Deluxe BS with riser installed. Because it was a show model I'm treating it like I'm assembling from scratch. I can't seem to get the wheels co-planar. The top wheel needs to move about 1/32" to 1/16" toward the back of the blade. I put a straight edge across the wheels and only get three points of contact. Is this normal? When I spin the wheels by hand the blade wants to run a bit forward of center on the bottom wheel.
It's not bad but I'm a perfectionist who's never used or setup a BS.
Thanks,
-Rocko
I just got a lightly used Jet 14" Deluxe BS with riser installed. Because it was a show model I'm treating it like I'm assembling from scratch. I can't seem to get the wheels co-planar. The top wheel needs to move about 1/32" to 1/16" toward the back of the blade. I put a straight edge across the wheels and only get three points of contact. Is this normal? When I spin the wheels by hand the blade wants to run a bit forward of center on the bottom wheel.
It's not bad but I'm a perfectionist who's never used or setup a BS.
Thanks,
-Rocko