Rob Will
11-30-2007, 10:33 PM
I have this idea to spell out a child's name in both sides of a 2"x3" x (??length) board with my CarveWright machine - and make a toy train out of the results.
The letters would be double-spaced so I can cut the board (letters)into individual blocks and round over the edges.
Install four wooden wheels on pegs to each individual block.
Drill the blocks lengthwise and thread them together with a tiny chain.
Run a screw up into the bottom of each block to lock the chain and maintain uniform spacing.
Fabricate a simple engine and caboose using similar wooden wheels.Add a short pull rope and viola, we have a "NAME TRAIN":D.
What do you think about this?
Any ideas to dress up the train? (easy details)
Thanks,
Rob
The letters would be double-spaced so I can cut the board (letters)into individual blocks and round over the edges.
Install four wooden wheels on pegs to each individual block.
Drill the blocks lengthwise and thread them together with a tiny chain.
Run a screw up into the bottom of each block to lock the chain and maintain uniform spacing.
Fabricate a simple engine and caboose using similar wooden wheels.Add a short pull rope and viola, we have a "NAME TRAIN":D.
What do you think about this?
Any ideas to dress up the train? (easy details)
Thanks,
Rob