John Nowack
11-25-2007, 12:16 PM
I call it a "mock" inside out ornament for lack of a better term. At some point I looked online at some instructions where the guy used a forsner bit to hollow out the inside of the ornament. Then simply turned the outside. It ended up like the ones you see with a christmas tree inside.
just trying to save some time before christmas. I have turned a couple of true inside out ornaments but it takes a while at my experiance level and I have the cheap introduction table sawswith a homade disc sander on the lathe. which means, the peices don't end up perfectly sqaure and I have to fight the project through every step.
Thought some one would know as I can't find it now
just trying to save some time before christmas. I have turned a couple of true inside out ornaments but it takes a while at my experiance level and I have the cheap introduction table sawswith a homade disc sander on the lathe. which means, the peices don't end up perfectly sqaure and I have to fight the project through every step.
Thought some one would know as I can't find it now