Todd Fulton
11-16-2007, 6:07 PM
I was trying to engrave some glass tree ornaments. After 1 finished, a statement popped up on the laser's screen.
"Y motor malfunction
For service please
inform your local
distributor"
After re-starting the laser, it would be fine. After finishing a project, same message.
I then tried a wine glass with 4 small graphics. It engraved 2 double sized graphics and popped up the error message again.
Any thoughts on this?
Thanks.
"Y motor malfunction
For service please
inform your local
distributor"
After re-starting the laser, it would be fine. After finishing a project, same message.
I then tried a wine glass with 4 small graphics. It engraved 2 double sized graphics and popped up the error message again.
Any thoughts on this?
Thanks.