Jerry Booher
11-10-2007, 3:24 PM
I just upgraded to a SawStop. I transferred my Incra LS rails and fence to the new saw. Nothing fit due to the 30" width vs. 28" and wider table than the old Delta. New rails, beam and fence. The router table is also too narrow, so I am going to build a new table. I have an Incra router fence so I need to use the LS Positioner that moves the fence. It mounts on the right. See incra.com and sawstop.com
My question is whether I should put the table on the left as it was or mount it on the right. The SawStop motor cover swings from the right about 11". What would you recommend?
Jerry
My question is whether I should put the table on the left as it was or mount it on the right. The SawStop motor cover swings from the right about 11". What would you recommend?
Jerry