Martin Reynolds
11-05-2007, 8:16 PM
I've been playing around with laser cut gears, with surprisingly good results. This project was about mounting a rotative reflector inside a pinball light about an inch high and wide.
http://www.iobium.com/mini_rotating_mars_light.htm
I have some problems with the site movies, but the top YouTube one is best.
For the really small gear, I need to tweak the geometry a bit but the cutting is pretty good on the larger one.
http://www.iobium.com/mini_rotating_mars_light.htm
I have some problems with the site movies, but the top YouTube one is best.
For the really small gear, I need to tweak the geometry a bit but the cutting is pretty good on the larger one.