PDA

View Full Version : Pulled the trigger (a pre-gloat)


Bruce Page
11-03-2007, 8:33 PM
After doing a reality check on getting a used ShopBot (where in the world would I put it?). I just finished ordering another long lusted after tool. I ordered a new PC 7518 router, a Bench Dog 40-016 ProLift and the Bench Dog 40-031 ProMax cast iron extension table for my Uni to mount it all into. Plus a few accessories to go with it.
I should all be here in a week or so. I can hardly wait!
Brian Weick
11-03-2007, 8:43 PM
Your going to really enjoy that PC 7518 3-1/4hp VS router with soft start- professional all the way,very rugged and well built ~ that router is a beast- now it's anticipation time!:eek:
Brian
Jim Becker
11-03-2007, 8:57 PM
Excellent choices, Bruce...pretty much what my router setup is these days for router table work! The BD stuff is really wonderful.
Bruce Page
11-03-2007, 9:03 PM
Your going to really enjoy that PC 7518 3-1/4hp VS router with soft start- professional all the way,very rugged and well built ~ that router is a beast- now it's anticipation time!:eek:
Brian

Thanks Brian. I know all about PC Beasties – I have a PC7539 mounted in the back end of my mill!
Don Bullock
11-03-2007, 10:03 PM
Congratulations Bruce. I'm sure that you'll show pictures once it's all set up.
Josh Youngman
11-03-2007, 11:01 PM
Where did you order the 7518 from? im looking to get one, looking for a good price.
Bruce Page
11-03-2007, 11:17 PM
Where did you order the 7518 from? im looking to get one, looking for a good price.
Josh, I got it from Amazon for $319.99 with free shipping. I didn't do a lot of shopping around but that was the best price that I came across (with shipping concidered)