View Full Version : New Lathe, bore in tailstock?
Bill Fleming
10-26-2007, 12:01 AM
I am thinking of a new lathe and wondering how many use the bore in the tailstock? My current lathe, which I will sell has a bored tailstock. Wondering if this should be a requirement on a new lathe. I have only used the bore to make a few lamps in the past but you never know?
Thoughts?
Ken Fitzgerald
10-26-2007, 12:12 AM
Bill, I could be wrong but I think most tailstock do have the bore capability but often have different diameters. I'm hoping to use mine between now and Christmas.
Bill Fleming
10-26-2007, 12:26 AM
Comparing the specs (since I didn't pay attention when looking) on the Powermatic 3520B vs the 4224 it appears that the 4224 has a bore in the tail stock and the 3520B does not?
Bill Fleming
10-26-2007, 12:32 AM
And the Jet 1642 does have a bored tailstock.
Ken Fitzgerald
10-26-2007, 1:11 AM
Bill...I checked the PM3520B MANUAL. The tailstock has a 3/8" hole through it and the head stock has a 5/8" hole through it.
Jon Lanier
10-26-2007, 1:52 AM
If it's bored, maybe your not using it enough. :p
Rick Huelsbeck
10-26-2007, 5:23 AM
Been 3 months since last use, will change on Sunday :D
Bill Fleming
10-26-2007, 10:23 AM
Thx Ken for checking that out - I did find it odd that the specs differed in that area but have also noticed that for a Robust lathe it is optional.
Chuck Jones
10-26-2007, 11:32 AM
eerrr, excuse me folks, but I'm kinda new at this. What's the bore for? My Jet 1642 has a hole through both the head stock and the tail stock, but I thought that was just for knocking the spur, chuck, live center, etc out.
Ken Fitzgerald
10-26-2007, 12:08 PM
Chuck.....they make special very long drill bits that you can mount in a handle and drill through lamp bodies for the electrical wires
Robert McGowen
10-26-2007, 1:43 PM
I use mine all the time to make rolling pins. I use 3/8" stainless steel threaded rod and turn them just like a giant pen.
Paul Engle
10-26-2007, 4:50 PM
In the head stock you can add a collet chuck which requires a long bolt to draw up the collet .
Ken Fitzgerald
10-26-2007, 7:04 PM
Chuck.....I also use the one in the headstock. I use a long bolt to hold the jacobs chuck with a morse taper in place. Then I can chuck up a mandrel and turn bottle stoppers.
Chuck Jones
10-26-2007, 9:33 PM
That's neat. I didn't have a clue. Probably never would have figured it out.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.